Industrial leak tightness tester for metal containers

Description

Industrial container tightness tester.

• Equipment for testing the tightness of containers with only 1 closed lid.
• Equipment for 3 – 8 containers depending on the container diameter, Ø52 (202) – Ø153 (603) mm
• Double safety actuator button
• Polycarbonate shields
• Water basin to check for leaks.
• Adjustable immersion time
• Pressure gauge to adjust the required pressure.
• Fully pneumatic operation.
• CE Marking

The operating cycle of the machine is as follows:

• Press and hold the two pushbuttons on the panel simultaneously with two hands.
• The upper arms close the clamp over the mouth of the boat and initiate immersion in the water raft.
• Once the complete lowering is done, we can release the push buttons and the machine injects pressurized air into the metal containers.
• The inspection on the surface is visual and the operator must look for any air leakage that occurs in a canister and is manifested by bubbling on the surface of the water.
• Once the inspection has been carried out and the suitability of the closure has been checked according to the customer’s criteria, we operate the two controls simultaneously again (this time we only press without holding) and the machine returns to its initial position, raises the raft assembly and once at the top opens the clamp, for a new check.